SEQUENTIAL GAS INJECTION SYSTEM

 EUROPEGAS BASICO 24 4 cyl + switch RGB

Set Include:

• ECU EG BASICO 24 4 cyl
• Electric wires
• Switch RGB 
• Reducer temperature sensor 4,7 Ohm
• Pressure and temperature sensor. Mapsenor
• Fuel Lever sensor HLS 

The smallest of the family of EG controllers. Features with extremely simplified installing process. Active Diagram Mode is based on installation diagram, which allows intuitive system callibration.

Technical specification

• Number of possible LAMBDA connectable: 0
• Automatic software updates
• Remining of installation service inspection
• Bluetooth and WiFi connection supported
• Active Diagram Mode – interactive calibration mode
• Automated tuning by pressing the switch buton without need
• of establishing connection with the PC
• Automatic adaptation of multiplier
• Calibration assistant
• Sound signaling when system errors occur
• Continuous maps collection
• No need for connecting the RPM wires
• No need for connecting the Ignition key 

  THE SMALLEST ON THE MARKET

  Modern reducer for sequential gas injection
  
  MAGIC III MINI 
  
  Original Magic III reducer - The latest revised version
  
  Thanks to the division of the special gas feeding system in the reducer with the help of a piston, which changes its operating characteristics, it is very efficient while maintaining a very small size.
  
  The reducer supports vehicles with a power not exceeding 150 HP
  
  
  Kit composition:
  
      Reducer
      Temperature sensor used     
      Mounting plate
       
  
  Technical data:
  

   

  DIMENSIONS:

   

  • Maximum capacity: 150KM
  • Working pressure: 0.8 - 1.4bar
  • Power supply: 6mm Cu copper wire or equivalent
  • Power socket: M10x1.0
  • Outer diameter of gas outlet nozzle: 12mm (six Allen screws available, where you can screw in the gas nozzle to change the outlet direction if necessary)
  • Outer diameter of water system nozzles: 16mm
  • Outer diameter of vacuum nozzle: 5mm
  • Operating temperature: -20°C ÷ 120°C
  • Temperature sensor resistance: 4.7kOhm

• height: 11 cm
• diameter: 6 cm
• width (including nozzles) 11.5 cm

Injectors Rail VALTEK

(complete with nozzles)
 

Originally calibrated by the manufacturer and ready to install in the car. It has built four gas injector with a single coil, which guarantees high performance, speed and precision gas dosing.

Ideally suited for gas injection systems:
STAG 200-300,4,PLUS,PREMIUM SIROCCO, KME DIEGO, ESGI, SEC i inne

Valtek Rail Type 30 3 Ohm.

A complete set of an AC / STAG LPG selenoid Valve

AC STD E-01 6x6mm

The task of the solenoid valve is to cut off the LPG supply to the reducer while driving on petrol, at a standstill or during a breakdown, and to filter the gas in liquid form before reaching the reducer.

Easy filter replacement.

Technical data:

     COIL POWER: 12V 8.5W
     LPG input / output: 6mm CU FI cable or equivalent
     Electrical connection: hairpins
     Liquid phase filter element: Paper exchangeable

Included:

     AC Selenoid Valve E-01 STD
     Mounting plate
     Mounting screws
     Nuts and washers
     Clamps and barrels for 6 mm Cu conductor