SEQUENTIAL GAS INJECTION

LPGTECH 224 4cyl.

The TECH-224 series are the modern microprocessor based controllers with 48 pin wire-set. The TECH-224 series controllers are designed for up to 4cyl. engines. Our controllers combine the advanced technologies with comprehensible functionality. The processor controlling the auto-calibration and auto-adaptation as well as the monitoring and correction system, is confined in to a small, waterproof plastic casing 114 x 140 x 36 mm. The material used in Tech-200 casing has identical properties to aluminum casing. This makes the TECH-224 controllers lighter, less costly and easy to install in every vehicle.

The TECH-224 controller is an expansion, more advanced processor in The TECH-224, allows more efficient command over the whole installation. Also, its software consists of additional settings such as the controller temperature measurement, the frozen frame maintenance and quicker oscilloscope. Additionally, the injection time control is more precise than in the standard version.
Advantages of TECH-224 series are: second slider to change the composition of the mixture at idle speed without need for re-calibration and non volatile errors memory, which allows to permanently saving of errors and it is circumstances during the drive.

Features drivers LPGTECH
Control algorithm TECH - advanced control algorithm eliminates the need for laying gas multiplier map and adjusting throttle control to the highest requirements of modern cars
Control Algorithm Standard - commonly used algorithm of multipoint gas injection gas injection time multiplier
Service loops petrol injectors and gas
Cooperation with VALVETRONIC engine type and engine Wankel
The ability to communicate through Moblin control application LPGTECH GASDROID
Direct cooperation program SETTING GAS LPGTECH configuration of wireless communication interface - BLUETECH
Three-dimensional map of the gas and gasoline
Automatic detection of petrol injection type
Adaptation - automatic selection of a multiplier based on injection time map
Automatic calibration system
Automatic switch to gas
Automatic switch to petrol when the gas is exhausted
Automatic calibration gas level indicator
The possibility of an adjustment speed
The possibility of introducing adjustments at a temperature regulator
The possibility of introducing the gas temperature correction
The possibility of introducing the gas pressure adjustment
The possibility of an adjustment of flow and gas injector opening time
The possibility of permanently disabled individual gas injectors (useful in case of failure of one of the injectors)
Visualization ECU injection times on petrol and gas
Cooperation with the normally-aspirated engines and turbocharged
Cooperation with various types of fuel injection control (Sequence, Półsekwencja, FullGrupa)
Heating gas injectors
The "Quick Start"
The "Filter turnover"
The full circuit and overload protection
Oscilloscope to observe the operation of the system parameters
Possibility of emergency starting on gas
Cooperation with many types of gas injectors

The kit include:
COMPUTER LPGTECH 224
CONTROL PANEL
(switch with full indication)
COMPLETE WIRING
MAP SENSOR
MOUNTING PARTS